How to install interior doors in a house
|
|
| Interior doors are decorations of modern houses. This process is a bit long and difficult and therefore requires maximum attention and certain knowledge. First of all, in order to install these doors, you must initially choose which type you want. Today our market provides a large selection for all tastes, you just need to be careful and choose a high-quality door.In order to install interior doors, you need to have some tools at hand. You must have a hammer drill, a drill, an electric cutter and circulars, a set of screwdrivers, a hacksaw, a chisel and a level. Before you start working, you need to prepare an opening. Doors cannot be installed if the walls are not yet dry or smooth, etc. The most important moment in installing doors is the installation of racks. If you have successfully installed it, then consider that half of the work is done. The racks must be measured from the outside, sawing off at an angle of 45 degrees to the height we need. A gap of about 1 cm should be left between the door and the floor, and a gap of about 0.5 cm should be left between the door and the upper crossbar. This means that considering the height of the buildings, it is necessary to take into account + 15 cm, except for the height of the door. The upper crossbar of the doors is the width of the door leaf + the thickness of the double posts and + another 1 cm is left for the gap.After these installations, you need to switch to the installation of door canopies. Measurements need to be set very carefully, taking into account every millimeter. Basically put two canopies. But if the door is very heavy, then a third canopy is also placed in the middle. After that, you need to measure the height of the seats with a loop. The upper hinge is placed 20 cm below the top, and the lower hinge is 21 cm above the bottom of the door.After the hinges are installed, you can already proceed to the installation of the door frame. It is necessary to measure the accuracy of the installation using a level. Once the door frame is installed, you will need to fix it with screws. Basically, 3 screws into the door frame will be enough. After that, you can foam all the voids with a mounting pen.The final part in the installation is the installation of platbands. This should be done after drying the mounting foam in the doors. The remains of the foam can be cut off with a knife, and then fixed with platbands using nails or screws or ordinary glue.That's the whole process of installing interior doors. Buy Cenforce Online: https://wheretobuyinus.com/product/cenforce/ cheap. |
|
|
|
